Section 1 · User commands
accel-config-config-user-default.1
Package: accel-config
On this page
ACCEL−CONFIG CONFIG
NAME
accel-config-config-user-default − load a pre−defined user default configuration
SYNOPSIS
accel−config config−user−default [<options>]
Without an option, config−user−default loads a pre−defined user default configuration.
There is a config file template at contrib/configs/user_default_profile.conf. Run “accel−config config−user−default −c user_default_profile.conf” to configure all available devices with the template values. Any modifications to the template file should retain the json format.
EXAMPLE
accel−config config−user−default
The command will load the pre−defined user default config to all available WQs and engines on all available DSA and IAX devices with the following attributes: All WQs and all engines are in group 0
WQ attributes:
priority: 1
group_id: 0
block_on_fault: 1
ats_disable: 0
prs_disable: 1
mode: “shared”
type: “user”
name: “user_default_wq”
driver_name: “user”
size: max WQ size / max WQs
threshold: size
max_transfer_size: default value
max_batch_size: default value on DSA. N/A on IAX
op_config: default value
Attributes of all devices and groups are default values.
accel−config config−user−default −c /etc/accel−config/contrib/configs/user_default_profile.conf
The command will load the specified user default config file. The config file is a template that specifies attributes and devices. User can edit the config file per requirements.
accel−config config−user−default −d −n <wq_name> The command will disable all WQs named <wq_name> (default name is “user_default_wq”).
OPTIONS
−c, −−config−file
to specify the location of the customized user default config file
−n, −−name
to specify WQ name which will be used to disable enabled WQs
−d, −−disable
to disable the configured devices and wqs
−v, −−verbose
verbose